Improved Surface Finish

Profilometer measurement of an electropolished stainless steel surface

Reviewed by Tom Harrison, member of the ASME BPE Surface Finish Subcommittee · Updated November 2026

The short answer: A lower surface roughness improves seals, lowers friction, reduces real surface area, makes cleaning easier and improves heat and light reflection. Mechanical polishing reaches a target finish by abrasion; electropolishing lowers it further, typically another 10–35%, by dissolving the microscopic peaks. Roughness is measured with a profilometer and reported as Ra per ASME B46.1. Harrison certifies mechanical finishes as low as 4 µin Ra and electropolished finishes to ASME BPE SF4–SF6.

How roughness is measured

A profilometer draws a diamond-tipped stylus across the surface and records the profile. Ra is the arithmetic average deviation from the mean line; RMS is the root mean square of the same readings and runs about 10% higher. Readings are reported in microinches or micrometers over a defined evaluation length. Harrison measures and reports Ra per part and per surface where a finish is specified. See Ra & RMS: Calculating Surface Roughness.

Getting to a specified finish

Mechanical polishing sets the starting point and removes visible defects. Electropolishing then removes the folded, stressed layer and lowers Ra by 30–50% of the starting value in ideal conditions, 10–35% in a tolerance-limited production run. A surface at 25–30 µin Ra after mechanical polishing will usually electropolish to 15 µin or better, the ASME BPE SF4 limit. A surface starting at 60 µin will not. Tell us the starting Ra, or let us do both steps. See ASME BPE Surface Finish Designations.

Where it matters

Sealing faces and valve seats, bioprocess product-contact surfaces, semiconductor gas and vacuum components, heat-transfer surfaces, and any part where product adhesion or cleanability is a problem. See Reduce Product Adhesion.

Standards: ASME B46.1 (surface texture measurement), ASME BPE Part SF, ISO 1302 grade numbers.

Drawing calls out an Ra you need certified? Send it with the material and current finish and we'll confirm what's achievable and quote with a profilometer report.

Send Us Your Drawing or call 800-245-5707, Mon–Fri 7–5 Central.

Related: Mechanical Polishing · Electropolishing · How to Specify a Finish

Frequently asked questions

How is surface finish measured?

With a contact profilometer that traces a stylus across the surface and reports Ra, the arithmetic average roughness, per ASME B46.1. Values are given in microinches or micrometers.

How much can electropolishing improve surface finish?

Up to 50 percent in ideal conditions and 10 to 35 percent in a typical tolerance-limited production run. The starting finish from mechanical polishing determines the achievable result.

What is the smoothest finish Harrison can certify?

Mechanical finishes as low as 4 microinch Ra, and electropolished finishes meeting ASME BPE SF4 at 15 microinch Ra maximum, with lower values achievable on request depending on part geometry.

Electropolishing

Harrison Electropolishing, the Leading Electropolishing, Passivation, Oxygen Cleaning & Mechanical Polishing Company World Wide.

Electropolishing is an electrochemical process by which surface material is removed by anodic dissolution. Electropolishing removes surface material, beginning with the high points within the microscopic surface texture. By removing these points, the electropolishing process will improve the surface finish of a metal such as stainless steel, nickel, and Hastelloy, leaving a smoother and more reflective surface. Common parts and components electropolished include tanks, piping, fittings, rods, discs, large parts & surfaces, and more.