Improved Cleanability and Sterilization With Electropolishing

Electropolished stainless steel surface with reduced microscopic surface area for easier cleaning

Reviewed by Tom Harrison, member of the ASME BPE Surface Finish Subcommittee · Updated November 2026

The short answer: A smoother surface has less real surface area and fewer microscopic crevices for product, soil and bacteria to hold onto. Electropolishing reduces Ra and removes the smeared, contaminated layer left by machining and abrasive polishing, so equipment cleans in less time, sterilizes more reliably and runs longer between cleanings. USDA research found bacterial biofilms are less likely to form on electropolished stainless steel.

How surface finish affects cleanability

Under magnification a mechanically polished surface is a field of ridges, folded metal and embedded abrasive. Residue lodges in those features and resists rinsing, and the folded metal shields bacteria from sanitizers. Electropolishing dissolves the ridges and the folded layer, leaving a rounded, open profile that drains and rinses freely. The passive, chromium-rich surface is also less chemically reactive with cleaning agents.

This is why ASME BPE requires electropolishing for its SF4, SF5 and SF6 product-contact finishes and why a mechanically polished surface at the same Ra does not qualify. See ASME BPE Surface Finish Designations.

What the improvement looks like in operation

Shorter CIP and SIP cycles, lower chemical and water use, fewer cleaning validation failures, and longer duty cycles between cleanings. In rouge-prone WFI and clean-steam systems, an electropolished and passivated surface slows rouge formation. When manual cleaning is required, polished surfaces wipe clean with less effort.

Equipment commonly electropolished for cleanability

Bioreactors and mixing vessels, process piping and manifolds, valves and fittings, filter housings, agitators, hoppers and screw conveyors, and food and beverage contact surfaces. Harrison electropolishes these to ASME BPE finishes and provides Ra reports and certificates of conformance. See Pharmaceutical Equipment and Biotech Equipment.

Reference: Lee, Jill, "Bacterial Biofilms Less Likely on Electropolished Steel," Agricultural Research, February 1998, pp. 10–11.

Cleaning validation or biofilm problem on product-contact equipment? Send the drawing with the current finish and we'll quote electropolishing to an ASME BPE designation.

Send Us Your Drawing or call 800-245-5707, Mon–Fri 7–5 Central.

Related: Stainless Steel Electropolishing · Rouge Removal · Passivation

Frequently asked questions

Does electropolishing reduce biofilm?

Yes. Electropolished surfaces have less microscopic surface area and fewer crevices, and USDA research found bacterial biofilms are less likely to form on electropolished stainless steel than on mechanically polished steel.

What finish should I specify for cleanability?

For pharmaceutical and biotech product-contact surfaces, ASME BPE SF4 (15 microinch Ra maximum, electropolished) is the usual specification. SF5 and SF6 are used where geometry makes 15 microinches impractical.

Is a mechanically polished surface at 15 Ra just as cleanable?

No. Mechanical polishing leaves folded metal and embedded abrasive that hold residue even at low Ra. ASME BPE treats a mechanically polished surface and an electropolished surface at the same Ra as different finishes for this reason.

Electropolishing

Harrison Electropolishing, the Leading Electropolishing, Passivation, Oxygen Cleaning & Mechanical Polishing Company World Wide.

Electropolishing is an electrochemical process by which surface material is removed by anodic dissolution. Electropolishing removes surface material, beginning with the high points within the microscopic surface texture. By removing these points, the electropolishing process will improve the surface finish of a metal such as stainless steel, nickel, and Hastelloy, leaving a smoother and more reflective surface. Common parts and components electropolished include tanks, piping, fittings, rods, discs, large parts & surfaces, and more.